TVU-STH Thread Verification Unit

Shown mounted on optional pneumatic linear actuator

Features

• Together with a separate linear actuator, quickly and automatically checks threaded holes (or external threads) by powering a probe (or ring gage) into and out of the part. GO gaging, NO GO gaging, and combination gaging are all possible.
• Sensitive high speed drive allows the probe to stop in case of missing or improperly formed threads. This registers a fault, creating a "reject" signal.
• Will check blind holes accurately for thread depth.
• Will not jam or stick in undersize (reject) threads. In automated applications, rejects can be separated out without stopping the process.
• Does not subject the part (or the Spindle) to high force or torque levels.even with a reject.
• Three basic models fit most applications.
• Quick to set up and use. Will mount in any orientation.
• Inspects a wide range of threads, with probe replacement the only changeover. The tool-free probe holder allows for quick change-out of probes.

• Unit includes matching servodrive, with motion programming. (fig. 1)
• Weighs 3 kilograms (6.6 lbs).
• Covered under U.S. Patent 7,059,055.

fig. 1

• Cycle times shown are for threads where the length is equal to the diameter and no Rapid Advance Mechanism is required.
• Most models available in stock.