1.
Tank Units
- Stainless
steel construction with two covers for easy access.
- Capacities
up to 200 gallons.
- Pump
motor starts at 1 H.P. and goes up for larger applications.
- Quick-disconnect
electrical (Sealtite) and fluid lines allow for
caster-mounted unit to quickly roll away for cleaning.
Extra self-contained tank units are available for
production runs that can't tolerate downtime.
- An
oversize chip basket (strainer) catches the larger
contaminants
- Baffles
- Drain
valve allows for quick purge of tank.
- Optional:
Fluid level switches control automatic water makeup
- Optional:
Dual skimmers if oil contamination is a factor.
- Optional:
Large-wattage heating elements warm water to 160
degrees. Optional tank insulation allows for higher
water temperatures or less energy consumption at
same temperature.
|
2.
Conveyor
- Variable
speed up to 6 parts per second.
- Overload
clutch protects the drive if a jam occurs
- Adjustable
side rails maintain orientation of part to provide
for targeted cleaning of key areas. Swing-away
in-process access door allows for periodic part
inspection.
|
|
3.
Wash and Rinse Compartment
- Targeted
nozzles clean parts on these oriented-parts washers.
Over-ported manifold allows for future supplement
of additional nozzles.
- Lexan
or stainless compartment access doors are easily
lifted off
|
4.
Bag Filter and Pump Discharge
- The
bag unit filters out smaller particles from 1
to 100 microns (depending on application).
- Inexpensive
bags are easily replaced.
|
5.
Strip Liquid
- Targeted
shop air or, for larger parts, high velocity
regenerative blown air removes most liquid to
prevent contamination of rinse (after wash) or
to aid drying (after rinse).
|
6.
Dryer
- 4,500
watt (or larger) dryer quickly vaporizes water
from part.
|
7.
Cooling Capability
- Reduce
heat of parts after drying to allow next-step
processing.
|
8.
Optional: Ground Fault Device
- To
protect in case of short circuit.
|
9.
Optional: Automated Loading and Unloading
- Parts
can be chuted into and out of washer; or New
Vista will design and build application-specific
material handling.
|
|
